Conductivity Monitor
Low cost for single use applications
Our Conductivity monitor requires no calibration because of pre-determined cell constant. They also feature optional one-point calibration by user and are low cost for single use applications.
Integrates With Conductivity Sensors
Our PendoTECH conductivity monitor was created to work with our sensors, and are qualified for use up to 10psi (5psi after gamma irradiation).
Overview
Featuring the ability to read temperature and conductivity, our PendoTECH Conductivity Monitor was created to work in tandem with our PendoTECH Single-Use Conductivity sensors. This sensor performs temperature normalization to 25°C with adjustable mS/ °C factor, as well as 4 – 20mA outputs for both conductivity and temperature. There are both panel mount and benchtop stand versions available.
Features & Benefits
- Reads 2 sensors
- Ability to read temperature only
- Reads conductivity and temperature from sensor
- Cell constant must be entered into the monitor when new sensor is connected
- Perform temperature normalization to 25°C with adjustable mS/ °C factor
- 4 – 20mA outputs for both conductivity and temperature
- RS232 output for data collection to a PC with PendoTECH PMAT Plus GUI software
- Panel mount kit and benchtop stand available
Documents
Applications
- Diafiltration
- Tangential Flow Filtration (TFF)
- Virus Filtration
- Harvesting
- Fill and Finish
- Perfusion
- Nano Filtration
- Chromatography
- Sterile Filtration
- Research
- Process Development
- As well as many other applications
Technical Specs
| Enclosure | WxHxD: 7.86inch x 4.47inch x 2.25inch (19.96 x 11.35 x 5.72cm) Approximate weight: 1.34 lbs (0.61 kg), Material: ABS Plastic NEMA 4X front panel; panel and wall mount optional |
| Keypad | 8 button keypad with LEXAN overlay |
| Display | 4 line backlit LCD |
| Power Inlet | D9 15-24 volts DC, 4 watts (powered by wall supply) Pin 1- ground; Pin 4- +24V |
| Sensors Input (s) | D15 female; Temperature Pin 7 (-), Pin 2 (+); Conductivity Pin 9 (high), Pin 12 (low) |
| Analog Output(s) | D15 male (screw terminal adaptor included as shown on right) Conductivity 4-20 mA Range: 0-100 mS Temperature 4-20 mA Range: 0-70°C Accuracy: 0.1% of full scale Sourcing with Maximum Load: 400 ohms |
| RS232 Output | Data output to a PC at frequency up to 1/sec. |
| Regulatory Compliances | RoHS and REACH Compliant CE Mark EN613261:2013; EN61010-1:2010 |
Related Products
PendoTECH Single-Use Conductivity Sensor
Our PendoTECH Single-Use Conductivity Sensors measure raw conductivity and temperature with no calibration required because of pre-determined cell constant.
PendoTECH Single-Use Temperature Sensor
Our PendoTECH Single-Use Temperature Sensor is a highly accurate sensor and features extreme sensitivity for the measurement of temperature.
